What is the cause of the wall sticking problem of materials in the three cylinder dryer?

The cause of the wall sticking problem of materials in the three cylinder dryer is
1. There are certain scale restrictions on the type of materials to be dried by each model of dryer, particle size, humidity and feeding speed of materials. If the humidity of materials is greater than the humidity scale of this type of dryer, some problems can occur, such as emerging materials sticking to the cylinder.
2. In the process of dryer manufacturing and installation, the reason that can emerge is that the position design of the axis and the time division of the device do not conform to the specification, forming the cylinder wall sticking with materials.
Ways to deal with the problems above the three cylinder dryer:
1. As for the humidity of materials, if conditions permit, we can manually control it and dry it naturally for a period of time.
2. The rare methods are: vibration method, air purging method, continuous elimination method of rotating scraper, continuous elimination method of rotating chain, and intermittent cleaning method of electric or pneumatic brush specially set for wall sticking parts. Some dryers have devices on them that vibrate and beat the dryers irregularly, perhaps because the devices have chains for continuous treatment.
3. If there is a relatively significant situation, we need to contact the consumer manufacturers and ask professionals to review the axial position of drying.